Features & Benefits:  
BatteryMINDer® Model 128CEC2-AA-S2: 12V 8 AMP GILL® Aircraft Battery Charger-Maintainer-Desulfator

These chargers-maintainers-desulfators are designed for all 12V GILL® G series and LT 7000 series. If you want the longest possible life and performance from your batteries there is no other product better at doing just this and BatteryMINDer® Guarantees it! BatteryMINDers are among the highest rated brand of products

• Guaranteed to never overcharge/undercharge. (33°F to 130°F)
• Tested and endorsed by leading Battery makers.
• 100% Full - Time U.S. Patented Pulse-type Desulfation keeps battery free of sulfate or dissolves sulfate completely in older batteries.
• Detects and rejects batteries with bad cells. Terminate charge to prevent out-gassing.
• Maximize battery life and capacity, recovers weak batteries.
• Diagnoses battery’s condition / state-of-charge.
• Recovers weak or deeply discharged batteries: including but not limited to flooded filler cap, maintenance-free, valve regulated lead-acid (VRLA), sealed lead-acid (SLA), starter, deep cycle and hybrid.
• Maintain up to 2 batteries at a time. (requires BatteryMINDer® Y-Connector Accessory 210-AY)
• Auto-Restart after power failure.
• Bad cell detection with auto-shutdown.
• Includes Short circuit, spark, reverse polarity protection, thermal runaway protection, automatic D/C disconnect on A/C failure and quick-connect/disconnect fused alligator clip assembly.
• Very high efficiency. California CEC Approved. Certified to California Energy Commission Standards.
• Automatically detects input AC power.
• ECO-mode with hi-efficiency / low power consumption. This allows the unit to always remain connected to AC while consuming very low level of electricity.
• Ambient temperature compensation. Built-in temperature sensor automatically adjusts charge rate to ensure full-charge. (as low as 0°F or as high as 130°F)
• 12 LED indicators show state-of-charge and important status mode / battery condition.
• Rugged, vibration-resistant construction.
  
  Never connect two or more batteries together before fully charging each and checking their condition. Failure to fully charge each battery and check their condition can result in a serious safety hazard.