A light reddish-pink tint
Free of chromates
Free from heavy metals
Low toxicity
Detectable & Non-Sagging Film
Fast Drying Non-Tacky Film
High Penetration
Non-Cracking and Non-Flaking To -65°F (-54°C)
> 3000 Hours Salt Spray
< 0.3 Mil (8 microns) Required To Surpass Specification
Solvent Removable
Very Low Dry Film Weight
Water Displacing

Intended for use on:

Upper edge floor beams
Wheel wells
Pressure deck
Center wing sections
Apply by conventional airless or air-operated spray equipment.

Aerosol application is also available.

The Cor-Ban® 23 aerosol can be used in conjunction with the Formit® extensions to provide targeted spray to areas that may be difficult to reach but need to be coated.  Please refer to our Formit® technical data sheet for more information.  The Cor-Ban® 23 aerosol can also be used with the Zip-Chem® Aerosol Trigger Sprayer which is designed for use with any Zip-Chem® aerosol can.

Refer to the Cor-Ban® 23 application manual for detailed application instructions. This manual can be obtained by asking your Zip-Chem® sales rep for a copy of this document.

All properties represented were achieved with a dry film thickness of range 0.3 – 0.5 mils (7-12 microns).

The wet film will self level to achieve the desired dry film thickness when applied to an inclined surface.

One aerosol can covers approximately 160 ft2 (14.9 m2).

One gallon (3.8 Liters) of bulk material covers approximately 2290 ft2 (56.2 m2/liter)

Store Cor-Ban® 23 at 40°F to 100°F (4.4°C – 37.8°C) in the original unopened containers.  Keep containers closed when not in use and protect Cor-Ban® 23 from direct sunlight.